Removing The Hdd; Removing The Battery - Packard Bell Vibe 300 Disassembly Manual

Removing the HDD

To remove the HDD, first remove the bottom cover (see section
Cover) and then follow the steps below:
1. Disconnect micro drive (pull drive while holding the flat cable). You can pull the
rubber cover from the micro drive, in case you need to replace the micro drive.

Removing the Battery

To remove the battery, first remove the bottom cover (see section
Cover) and then follow the steps below:
1. Disconnect the battery from main board and lift it out. Do not pull the cable, as
this might tear the cables from the connector. In case the cable does not loosen
easily, use a flat blade screwdriver to push the connector out of the main board
connection.
Fig. 3 Vibe 300 without bottom cover.
Fig. 4 Removing the micro drive.
Packard Bell Vibe 300 Disassembly Manual
Removing the Bottom
Removing the Bottom
4