Reset To Default Settings - X-10 X10 PRO XP4LS Installation And Operating Instructions Manual

Advanced Programming Option 9
1) Enter Mode 5. See To Enter any Mode section.
2) Press Advanced Programming Option 9. Press key "9" which is defined in the
following table.
3) Press All-Lights-On key. Product confirms Option Number is entered.
4) Press the Receive Level. A number between 1 and 16 representing the voltage
receive level of the product. The default is "4" (50mV). The "1" key is 5mV, "7" is
125mV, "11" is 225mV, "14" is 300mV, and "16" is 350mV.
5) Press All-Lights-On key. The product stores new setting into memory.
6) Press All-Lights-On key 3 times. The product is transferred out of programming
mode and into normal operation.
Numbered Key on
Transmitter/Controller
1
2
3
4
5
6
7
8
9
10

RESET TO DEFAULT SETTINGS

The following steps will return this product to its default settings as given on the next
page.
1) Enter Mode 1. See To Enter any Mode section.
2) Press All-Units-Off key 3 times. This will reset to factory defaults.
3) Press All-Lights-On key 3 times. The product is transferred out of programming
mode and into normal operation.
Advanced Programming
Option
Soft Start
All Lights On
All Lights Off
All Units Off
Universal All Lights On
Universal All Lights Off
Universal All Units Off
Master Scene Enable
Receive Level
Remote Access
ADVANCED PROGRAMMING OPTIONS
Page 10
Default Setting
Enabled
Enabled
Enabled
Enabled
Disabled
Disabled
Disabled
Disabled
4
Disabled