To Enable Snca To Work With Web Server - Sun Microsystems Sun Java System Web Server 7.0 Manual

Solaris Platform-Specific Issues
■
■
■
■
■
▼

To Enable SNCA to Work With Web Server

This procedure assumes that SNCA has been configured, as discussed above.
From the Common Tasks page, choose a configuration and click Edit Configuration.
1
Click the HTTP Listeners tab and select the HTTP listener to edit.
2
On the Edit HTTP Listener page, set the Protocol Family to nca.
3
The HTTP listener must be listening on port 80 for this to work.
Save your changes.
4
Click the Performance tab.
5
Click the Cache sub tab.
6
On the Cache Settings page, make sure the file cache is enabled and enable Use Sendfile.
7
Save your changes.
8
Redeploy the configuration for your changes to take effect.
9
Maximum Threads and Queue Size
When configuring Web Server to be used with SNCA, disabling the thread pool provides better
performance. These settings are on the configuration's Performance tab ⇒ HTTP sub tab,
under Thread Pool Settings. To disable the thread pool, deselect the Thread Pool Enabled
checkbox. You can also disable the thread pool using the wadm set-thread-pool-prop
command's enabled property.
The thread pool can also be disabled with non-SNCA configurations, especially for cases in
which short latency responses with no keep-alives must be delivered.
92 Sun Java System Web Server 7.0 Update 1 Performance Tuning, Sizing, and Scaling Guide •
nca(1)
snca(1)
nca.if(4)
ncakmod.conf(4)
ncalogd.conf(4)