Related Manuals for Vax CADENCE V-044
Summary of Contents for Vax CADENCE V-044
-
Page 1: Instruction Manual
Vax Careline: 0870 6061248 www.vax.co.uk Please read carefully before using BAGLESS UPRIGHT VACUUM CLEANER the cleaner. Always fully extend Vax Model Number: V-044/V-044T the mains cable before use. Instruction Manual... - Page 2 Parts Overview 1. Diagram FRONT BACK Fig.1/1 Handle Dirt container button release Dirt container lid Crevice tool HEPA filter Extension tube Dirt container Hose clip Lower hose inspection tube Extendable hose On/off switch Power cord Carpet height adjuster Hose connector Vacuum head Lower cord wrap with quick release Wheel...
-
Page 3: Safety Information
IMPORTANT: If the vacuum inlet or hose is blocked, dropped into water. Return the vacuum cleaner to switch off the vacuum cleaner and remove the a Vax Authorised Service Agent or suitably blockage(s) before re-starting the vacuum cleaner. qualified person for examination, repair or adjustment. -
Page 4: Use & Function
How to Assemble / How to Operate 3. Use & Function IMPORTANT: Always remove the power plug from the electrical outlet before assembling or removing accessories. Assembling the Dirt Container 1. Insert the bottom of the dirt container to align with the tab on the upper cover of the motor. - Page 5 Accessories/Dirt Container & Filter: Removal & Replacement/Belt or Brush removal and replacement Fig.4/4 Fig.6/1 Cleaning the HEPA Filter IMPORTANT: When the vacuum cleaner is stood in Remove the dirt container lid by grasping the dirt the upright position or when using the hose and tools, container and turning anti-clockwise (Fig.6/2).
-
Page 6: Maintenance
Dirt Container & Filter: Removal & Replacement/Belt or Brush removal and replacement/Maintenance Cleaning the Pre-Motor Filter 3. Lift the right side of the brushbar and lift the left hand side and remove the brushbar from the power head Underneath the dirt container is a pre-motor filter. If (Fig.7/1). -
Page 7: Troubleshooting
Troubleshooting 8. Troubleshooting WARNING: TO REDUCE RISK OF PERSONAL INJURY UNPLUG VACUUM CLEANER BEFORE SERVICING PROBLEM: Cleaner won’t run Cause: Not properly plugged into electrical outlet. Solution: Plug cord in firmly. Cause: No electricity in wall outlet. Solution: Check fuse or breaker. Cause: On/off switch not turned on. -
Page 8: Technical Specification
Please make a note of the model number and serial number of your Vax before calling. There are over Subject to technical change without notice. 400 approved Vax Service Agents in the UK. For the nearest Vax Service Agent, please call the Vax Careline or visit www.vax.co.uk... - Page 9 This page has been left intentionally blank.
- Page 10 This page has been left intentionally blank.
- Page 11 This page has been left intentionally blank.
- Page 12 EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility declare that the products V-044/V-044T Cadence are manufactured in compliance with the following: Safety: 73/23/EEC Low Voltage Directive, as modified by 93/68/EEC EMC: 89/336/EEC Electromagnetic Compatibility Directive, as modified by 93/68/EEC Waste electrical products should not be disposed of with household waste.