Emptying The Dirty Water Tank - Vax Rapide XL Ultra V-027X Instruction Manual

V-027X User Guide 7/9/06 15:04 Page 10
19
Insert the four AA batteries into
your Power Wash Brush in
locations shown. Next see section
17 for machine preparation.
Emptying the dirty
water tank
1
20
Depress the dirty water tank latch
and simultaneously pull the dirty
water tank nozzle tab up and away
from the cleaner.
Oscillating Brushes
Now attach the Power Wash Brush
to the hose attachment by pushing
hose end into Power Wash Brush
until it clicks into place. In order to
release solution onto the desired
areas depress the blue solution
spray trigger. Release the trigger
and press the Power Button to
activate the Power Wash Brush.
Use Brush on desired areas, repeat
as necessary.
2
Remove the dirty water tank by
lifting the dirty water tank handle
and pulling the tank out of the base.
Note: The nozzle does not need to
be completely removed to empty
the dirty water tank.
Battery Compartment 2
Hose Release Button
Battery Compartment 1
To rinse, remember to turn the soap
switch to the OFF position and repeat
process. If further drying is required
switch off the Power Wash Brush and
go over the area again. To remove
Power Wash Brush from hose push
Release Button as shown. When
finished See section 18 parts 8-11 for
disconnection and storage
instructions.
3
Place the dirty water tank over a
large sink and remove the dirty
water tank cap by twisting it to the
left (counterclockwise) and out in a
safe place. Empty the water into
the sink.
Power Button