Vauxhall Antara Owner's Manual page 173

Picture no: s0013693.ti f
2. The location of front and rear jacking
points is ind icated by notches on the
bottom edge of the vehicle, under the
doors.
Picture n o: s0013694.tif
3. Attach wheel bolt wrench to jack head
and rotate w rench clockwise to raise the
lifting head a little.
Position jack at the front or rear ja cking
point located nearest to the wheel
concerned so tha t the jack claw spans
the vertical b ase. Ma ke sure it is
perpendicular to the ground a nd
properly positioned .
The ja ck base must b e on the ground
directly below the jack ing point in a
manner that prevents it from slipping.
Self-help
Picture no: s0013727.tif
4. Raise vehicle b y rotating wheel bolt
wrench clockwise until jack head fits
firm ly into the app ropriate notch a nd the
tyre is ap prox . 2.5 cm off the ground.
If this is not the ca se, carefully lower the
vehicle immediately and reposition the
jack so that it cannot slip.
5. Unscrew wheel bolts completely b y
turning anticlockwise and put
somewhere w here the threads w ill not b e
soiled.
169