Table of Contents
Advertisement
Quick Links
INTRODUCTION
The TC-NT1 Network Cable Tester is an innovative, practical tester that can easily read
the correct pin configuration of 10BASE-T, 10BASE-2, RJ45/RJ11 modular, 258A, TIA-
568A/568B and Token Ring cables by comparing one transmitting end to the
corresponding receiving end. The included remote terminator allows the user to test
installed cable either at a wall jack or a patch panel. Verifying continuity and testing for
faults such as open, shorted and crossed pairs has never been easier and more affordable.
FEATURES
• Displays the actual pin configuration of 10BASE-T and 10BASE-2 Ethernet,
RJ45/RJ11 modular, 258A, Tia-586A/586B and Token Ring cables
• Provides easy to read continuity and fault status display
• Checks for continuity, open wire, shorted pair and crossed pair faults
• Allows for remote testing of installed cables from wall jack or patch panel
• Tests shield wire integrity
• Auto or manual scanning
PACKAGE CONTENTS
1. TC-NT1 Master Unit
2. TC-NT1 Remote Unit
3. RJ11 Connector Adapters (Qty. 2)
4. RJ45 Male to BNC Male Adapter Cable (Qty. 2)
5. RJ45 UTP Patch Cable
6. BNC Female/Female Coupler
<Diagram 1>
PRODUCT PROFILE
<Diagram 2>
OPERATION
I. Loopback Test
1. UTP/STP Cable Test
1.1. Plug one end of the tested cable into the transmitting RJ45 jack on the master
unit marked with a '[arrow]' and the other end of the cable into the remaining
receiving RJ45 jack
Advertisement
Table of Contents
Related Manuals for TRENDnet TC-NT1
Summary of Contents for TRENDnet TC-NT1
- Page 1 INTRODUCTION The TC-NT1 Network Cable Tester is an innovative, practical tester that can easily read the correct pin configuration of 10BASE-T, 10BASE-2, RJ45/RJ11 modular, 258A, TIA- 568A/568B and Token Ring cables by comparing one transmitting end to the corresponding receiving end. The included remote terminator allows the user to test installed cable either at a wall jack or a patch panel.
- Page 2 1.2. Slide power switch on. The upper row of LEDs will start to scan in sequence if the Auto/Manual button is set on "Auto" mode. The LED for pin 1 will light up if the button is in "Manual" mode. 1.3.
- Page 3 2. As Coaxial cable has only two wires, we suggest you read the result of the LED scan using Manual mode. <Diagram 6> II. Remote Test 1. Plug one end of the tested cable to the transmitting RJ45 jack on the master unit marked with a '(' and plug the other end into the remote terminator.
Need help?
Do you have a question about the TC-NT1 and is the answer not in the manual?
Questions and answers