Fog Lamps; Taillamps, Turn Signal; Stoplamps, And Back-Up; Lamps - Buick Verano Owner's Manual

10-26 Vehicle Care
2. For the driver side bulb, remove
the windshield washer bottle
filler neck by firmly pulling it
straight up and out of the bottle.
3. Remove the headlamp bulb
access cover.
4. Turn the bulb counterclockwise
and pull straight back.
5. Disconnect the wiring harness
connector from the bulb.
6. Install the new bulb in the
headlamp assembly by turning
clockwise.
7. Reconnect the wiring harness
connector.
8. Install the headlamp bulb access
cover.
9. For the driver side, reinstall the
windshield washer bottle filler
neck by firmly pushing it straight
into the bottle. Ensure that the
filler neck clip engages into the
underhood electrical center
retainer.
Parking/Turn Signal Lamp
1. Open the hood. See Hood on
page 10 4.
2. Remove the parking/turn signal
lamp bulb socket from the
headlamp assembly by turning
counterclockwise.
3. Remove the bulb from the bulb
socket by pulling it straight out.
4. Install the new bulb in the bulb
socket.
5. Install the bulb socket into the
headlamp assembly by turning
clockwise.

Fog Lamps

To replace the front fog lamp bulb:
1. Locate the fog lamp located
under the front fascia.
2. Disconnect the electrical
connector from the fog lamp bulb
assembly.
3. Remove the bulb by turning it
counterclockwise and pulling it
straight out of the assembly.
4. Install the new bulb by turning it
clockwise into the assembly.
5. Reverse Steps 1–3 to reinstall.

Taillamps, Turn Signal,

Stoplamps, and Back-Up

Lamps

Trunk Deck Inboard Taillamp
and Back-Up Lamp