Receiving A Call; Using The "Dial" Or "Call" Command; Using The "Digit Dial" Command - Buick Verano Navigation Manual

1. Press / .
2. Say Dial or Call.
3. Say the entire number without
pausing or say the name tag.
Once connected, the person called
will be heard through the audio
speakers.
The digit dial command allows a
phone number to be dialed by
entering the number one digit at a
time. After each number is entered,
the system repeats back the number
it heard followed by a tone.
If an unwanted number is
recognized by the system, say
Clear at any time to clear the
last number.
To hear all of the numbers
recognized by the system, say
Verify at any time.
1. Press / .
2. Say Digit Dial.
3. Say each digit, one at a time,
that you want to dial. After each
digit is entered, the system
repeats back the digit it heard
followed by a tone. After the
last digit has been entered,
say Dial.
Once connected, the person called
will be heard through the audio
speakers.
1. Press / .
2. After the tone, say Re dial.
Once connected, the person called
will be heard through the audio
speakers.
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
Press / to answer the call.
Press / to ignore a call.
Call waiting must be supported on
the cell phone and enabled by the
wireless service carrier.
Press / to answer an
incoming call when another call
is active. The original call is
placed on hold.
Press / again to return to
the original call.
To ignore the incoming call, no
action is required.
Press / to disconnect the
current call and switch to the call
on hold.