Replace Lightbulb; Clearing Clogs - Bissell PowerForce 6564 SERIES User Manual

Replace Lightbulb

Use only BISSELL Replacement Bulb (#203-1007) in
your BISSELL PowerForce Bagless.
Unplug cleaner from electrical outlet
1.
Using a flat screwdriver, table knife or coin, insert into the
2.
slot on the right of the Lens and gently push inner latch to
the left as shown to remove the lens.
Remove the bulb from the socket by pushing in gently
3.
and turning it counterclockwise. Install the new bulb by
pushing it gently into the socket and turning clockwise.
Reposition lens, by inserting tab on left side and then
4.
pushing the right side back into place.

Clearing Clogs

Low suction, poor pickup, or no suction may be due to
a clog in the vacuum cleaner. If you notice a change in
the sound of the motor or a reduction in the spinning
action in the Dirt Container, check for clogs.
Unplug cleaner from electrical outlet.
1.
Empty Dirt Container.
2.
Check Upper Tank and Louvers for build up or clogs.
3.
Check to make sure Louvers are installed correctly. To
unlock the Louvers, grasp the rim and turn toward the
left. Pull straight down to remove. If the Louvers are miss-
ing or not locked into place, check and clear the tube in
the center of the Dirt Container.
Remove the Twist 'n Snap Hose from the vacuum by
4.
turning to the left. Check the Suction Inlet, Hose and Hose
Wand for clogs. Remove any clogs from the hose using a
long, narrow object.
Check the Foot Hose for clogs. If needed, remove the screw
5.
attaching the Hose Wand Base to the vacuum. Straighten
the Foot Hose and unclog with a long, narrow object.
If the clog persists, follow the instructions for Checking
6.
the Rotating Floor Brush on page 10 and inspect the Air
Passageway for obstructions.
Louvers
Hose
Wand Base
Air Passageway
Suction
Inlet
11