Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Badger Basket Anthem 155
Summary of Contents for Badger Basket Anthem 155
- Page 1 MODEL 155 INSTRUCTION BOOK U.S. Patent #5,779,157...
- Page 2 SPECIAL NOTE: Read instructions for proper care in handling and operation. Use in well ventilated area. Always read and follow instructions, cautions, and warnings on materials being sprayed. See back page for further information. At BADGER AIR-BRUSH CO. we are extremely proud of our people and our products. Our continued growth and success is based upon high quality and conscientious craftsmanship in the manufacture of each and every BADGER product.
- Page 3 onto. A fine line or small dot is achieved by working very close to the surface while releasing a very small amount of paint. A broad spray pattern is achieved by moving the airbrush back from the work surface and pulling back further on the trigger to release a larger amount of paint. The proper mechanics for triggering the airbrush are –...
- Page 4 Place the new tip into its seat in the airbrush body (see photograph 1), and then screw the head ™ and spray regulator onto the airbrush body. The head assembly on the Model 155 is designed to be tightened firmly by hand – use of pliers or other tools should not be necessary! Before spraying, reseat the needle into the new tip by pushing the needle forward until it stops.
- Page 5 MODEL 155 ™ ™ AIRBRUSH 51-085 51-075 50-019 50-046 50-042 41-033† 51-071 51-073 41-034 50-031 51-010 41-004 51-043 50-030 50-044 51-069 41-003† 51-048 50-013 51-048DT† 50-0141 50-014 50-020 50-015 50-2011 Hose can be used with 50-036 50-208 50-0052 compressor fitting or propel valve. 50-0482 †Adaptable Hybrid airbrush parts *The PTFE Needle Bearing carries a lifetime warranty and free replacement at the factory only.
- Page 6 MASKING OFF In the next several exercises you will need to mask off a square area. Make a mask from 4 pieces of scrap paper (fig. 8). These masks are held in place by masking tape, keeping the atomized material from creeping into the margins around the area.
- Page 7 TECHNIQUES TO USE Masking or frisket is used mostly to create a sharp edge or when more than one color is applied. A new frisket is cut for each color and covers any area that should not ™ be sprayed. Badger’s Foto/Frisket Film is specially formulated for use on all surfaces commonly used for airbrushing.
- Page 8 effect is desired. 8) Bubbles through the color cup. The spray regulator might be turned out too far, or the head may be loose. Check both and tighten if necessary. 9) Color spray cannot be shut off. Tip may be clogged. This is recognized by a “spongy” feel when needle is set into tip.
Need help?
Do you have a question about the Anthem 155 and is the answer not in the manual?
Questions and answers