Introduction; Computer Requirements - Audio Technica AT-MX381 SmartMixer Software Manual

Each AT-MX381 includes the SmartMixer Software application on CD Rom. This application allows the
installer to configure many of the AT-MX381 features without needing to open up the unit or remove it from
a rack. To use this powerful configuration tool, load the application onto a PC running the Windows
operating system (Win 98-SE, 2000, or XP), connect the PC to an AT-MX381 (Master Unit in a multiple
SmartMixer setup) via the RS232 data port, and run the application.
Functions configurable through the software include
Function
Input Attenuation 0 dB (MIC), -35 dB (LINE)
Phantom Power (Per Input)
Channel Priority Select (Per Input)
Threshold Level
Mode (Manual/Auto Mixer)
Output Attenuation (MIC/LINE)
Force – ON Override (Per Input)
Force – OFF Override (Per Input)
Direct Output Select (Pre/Post Gate)
NOMA
Gate Hold Time
Gate Attenuation (Per Input)
Low Cut Filter (Per Input)
"Last Mic On"
Output Limiter (Overall)
Output Level Indicator (Pre/Post Master)
Lock Mode (Control Lockout)
To run the SmartMixer Software, the following minimum computer hardware and software configuration
are required:
Hardware:
Pentium™ processor running at 166 MHz or better
100 MB hard disk space recommended for application
32 MB RAM
9 pin RS232 Serial Data Port (Com Port) to connect to
AT-MX381
CD ROM Drive
Computer display capable of supporting at least 1024
x 768 pixel resolution
Note: SmartMixer Software will not run on a LINUX® or Apple® Macintosh® based system.
Note: the SmartMixer Software requires the Microsoft .NET framework. If your
computer does not have .NET framework installed, you will be asked to install it during
setup. After installation, you will be asked to restart your computer.

Introduction

:
Default setting
0 dB (MIC)
Off
Off
8 (When PC is connected)
Auto Mixer
0 dB (MIC)
Off
Off
Pre Gate
Off
0.5 Second
36 dB
Off
On
Off
Pre Master
Disabled

Computer requirements

Operating System / Software
Microsoft® Windows® 98 and up including the
following versions:
98 second edition
NT 4.0 with Service Pack 5
2000 Professional with Service Pack 2 or Higher
2000 Server with Service Pack 2 or Higher
2000 Advanced Server with Service Pack 2 or Higher
XP Home
XP Professional
3