Related Manuals for Patton electronics 1000CC
Summary of Contents for Patton electronics 1000CC
-
Page 1: User Manual
USER MANUAL MODEL 1000CC RS-232 Rack Mount Controller Card SALES OFFICE Part# 07M1000CC-A (301) 975-1000 Doc# 022010UA TECHNICAL SUPPORT Revised 9/22/95 (301) 975-1007... - Page 2 1000CC can be done locally or remotely. To accomplish remote daisy- 1.2 SERVICE chaining, the daisy-chain port of a Model 1000CC is connected to a Patton short range modem card. The terminal link is then driven to a All warranty and non-warranty repairs must be returned freight remote rack with a second short haul and a Model 1000CC.
-
Page 3: Rear Card Configuration
In the open (disconnected) position, pin 1 is “lifted” from frame ground. 3.1 REAR CARD CONFIGURATION The rear card supplied with the Model 1000CC is equipped with two Position 1&2 = SGND and FRGND Connected modular RJ-45 jacks (see Figure 1, below). The jack labeled “A1” is for Position 2&3 = SGND and FRGND Not Connected... -
Page 4: Installation
This section describes the functions of the Model 1000R16P rack Replacing the Power Supply Fuse chassis, tells how to install front and rear Model 1000CC cards into the chassis and provides diagrams for wiring up the interface connections The rack chassis power supply uses a 400mA fuse for 120V AC correctly. - Page 5 ”high” (+8V). 1) Using a straight through modular cable, connect the serial port of the RS-232 terminal to Port A1 of the first Model 1000CC in When making a connection between port A1 and the serial port of the chain.
-
Page 6: Operation
2) Using a straight through modular cable, connect Port B1 of automatically applied to the 1000CC when its card-edge connector the local Model 1000CC to port A1 to the RS-232 port of a Patton touches the chassis’ mid-plane socket, or when the chassis’ power is asynchronous short range modem card (ex. -
Page 7: Appendix Aspecifications
APPENDIX B SPECIFICATIONS FACTORY REPLACEMENT PARTS Transmission Format: Asynchronous, RS-232 The Patton Model 1000CC rack system features interchangeable rear half cards, power cords/fuses for international various operating Data Rate: 0 to 19.2 Kbps environments and other user-replaceable parts. Model numbers and... - Page 8 APPENDIX C MODULAR INTERFACE PIN-OUTS MODULAR INTERFACE - 10 Wire RJ-45 (EIA-561) Contact Number Circuit Description Not Used Received Line Signal Indicator (CD) 108 / 2 DTE Ready (DTR) Signal Common Received Data Transmitted Data Clear to Send 105 / 133 Request to Send / Ready for Receiving Not Used Pins 2-9 conform to the EIA/TIA-561 eight position non-synchronous interface standard.