Table of Contents
Advertisement
Connect the barrel-type connector of the AC adaptor to the barrel-type power jack on the ipRocketLink.
2.
Insert the male plug of the AC power cord into an AC power outlet (100–240 VAC)
3.
1.3 Models with internal DC power supply
1.
Strip insulation 1/4-inch from the electrical wires that will connect the DC power source to
the ipRocketLink.
2.
Connect the ground terminal from the power source to the ground terminal on the ipRocketLink.
3.
Connect the negative (-) terminal from the power source with to the negative (-) terminal on
the ipRocketLink.
4.
Connect the positive (+) terminal from the power source with to the positive (+) terminal on
the ipRocketLink.
1.4 Power-up indication
The Power LED blinks as the ipRocketLink is powering up. When the Power LED stops blinking and remains lit,
the ipRocketLink is ready for you to configure.
The ipRocketLink is shipped with a factory-configured IP address assigned to the Ethernet LAN port (green out-
line). The address is 192.168.200.10/24. In most cases, you must change the address to be on the same
subnet as your PC, as described in the procedures below. If you are not sure which IP address to use for your
installation, contact your network administrator.
2.1 Connect a PC and log in
Using the included combination RS232/Ethernet cable and DB9-RJ45 adapter, connect a PC's serial port
1.
to the ipRocketLink's Console port (see
L o
r m
N o
m o
R e
s
a t u
S t
e t
r n
h e
E t
l
r i a
S e
n c
S y
Connect to Console port
A N
W
ipRocketLink 3086FR Quick Start Guide
2.0 Configure the IP address
i n k
t L
k e
e
o c
v i c
i p R
D e
s s
c e
6
0 8
A c
l 3
t e d
d e
r a
e g
M o
n t
L I
o l e
D S
n s
S H
C o
G .
s
d e
E
l
1 1
m a
M o
- 5
o r
- N
s t
1 1
T e
- 5
l -
c a
-
a l
-
t e
Connecting ipRocketLink to the PC's serial port
Figure 1.
figure
1).
.
PC with
terminal emulator
Serial port
3
Advertisement
Table of Contents
