Advertisement
2.
Hold the adapter board by the top corners and slide it into the
expansion slot. The board's edge connector (as shown in Figure
1-5) fits into the computer's motherboard expansion slot. Press
on the board as you insert it into the expansion slot. Check that
the board is seated properly by pressing down firmly on both ends
of the board.
3.
After the board is seated firmly in the expansion slot socket,
secure the board using the plastic clip that is on the end of your
board. Place the screw over the clip and slot cover. Then screw
the clip and slot cover to the computer case.
Western Digital Corporation
Figure 1-4. Installing Clip
Installation Guide
1-5
Advertisement
