Advertisement
This board does not work with XT drives or systems. If you have an
XT drive and system, you need the WDXT-140 or WDXT-150.
You need to know the types of devices that you plan to connect to
your adapter board in order to configure the board properly.
Identify Board
Figures 1-1 through 1-3 show the connector and jumper locations
for the WDAT- 140, WDAT-240, and WDAT-440 adapter boards.
Look at the illustration for the board you are using and locate
each connector and jumper block. Familiarize yourself with these
locations. Note that the connector and jumper names are also marked on
the board itself.
Handle the WDAT by the ends of the board. Some of the
chips are static sensitive and damage may occur if the
board is incorrectly handled.
CAUTION
Figure 1-1. WDAT- 140 Adapter Board
Advertisement
