Related Manuals for Denso MovinCool Condensate Pump
Summary of Contents for Denso MovinCool Condensate Pump
-
Page 1: Condensate Pump
MANUAL INSTALLATION CONDENSATE PUMP READ THIS MANUAL CAREFULLY FOR INSTRUCTIONS ON CORRECT INSTALLATION AND USAGE, AND READ ALL SAFEGUARDS. DENSO SALES CALIFORNIA, INC. REGISTERED TO ISO 9002 FILE NO. A5537... - Page 2 © 2005 DENSO SALES CALIFORNIA, INC. All rights reserved. This book may not be reproduced or copied, in whole or in part, without the written permission of the publisher. DENSO SALES CALIFORNIA, INC. reserves the right to make changes without prior notice. MovinCool is a registered trademark of DENSO Corporation.
-
Page 3: General Warnings And Cautions
FOREWORD Congratulations on purchasing a MovinCool Condensate Pump. This manual explains how to install the condensate pump onto MovinCool units. Please read this installation manual thoroughly to familiarize yourself with the features of the unit and to ensure years of reliable operation. - Page 4 INVENTORY After unpacking your Condensate Pump Kit, please check to make sure you have the following items: Condensate Pump (1) Hose, 3/8 inch diameter, 20 feet Small Screws (2) Bolts (2) (Not required for OP36) Adapter Plate (Not required for OP36) Note: If any of these items are not included in the box or appear damaged, please contact your MovinCool reseller for replacement.
-
Page 5: Pump Installation
PREPARATION Remove Condensate Pump from package. WARNING: Make sure the MovinCool unit is unplugged from the electrical outlet or if permanently wired, make sure circuit breaker is in the off position. PUMP INSTALLATION Secure pump to adapter plate using the two screws supplied in the kit. - Page 6 PUMP INSTALLATION Remove jumper plug from mat- ing connector. Connect pump to mating connector on inside panel or to adapter harness. Note: 115v and 230v pumps have unique connectors. See matrix on next page. For OP36 Only Plug pump connector into match- ing connector in rear frame.
- Page 7 PUMP INSTALLATION Secure pump to side panel with the screw provided. Note: Pump is unique to voltage check model matrix below for correct pump. CPK115 CPK230 MODELS CPK115 CPK230 Office Pro 12 Office Pro 18 Office Pro 24 Office Pro 36 Classic Plus 14 Classic Plus 26 Classic 10...
-
Page 8: Hose Installation
PUMP INSTALLATION Remove tab from pump. HOSE INSTALLATION 9" Note: The Condensate Pump Kit is equipped with a 20 foot hose. This hose will be used as both a drain and an inlet hose for the Condensate Pump. Cut a section of the 20-foot hose suffi... - Page 9 HOSE INSTALLATION For OP36 Only Connect the remainder of the 20 foot (6 m) hose to the drain outlet DRAIN STEM spout and feed it through the DRAIN HOSE grommet on the right hand side of DRAIN HOSE the unit. DRAIN HOLE Note: Do not use more than 20 feet (5.5m) of drain hose verti-...
-
Page 10: Maintenance And Troubleshooting
MAINTENANCE & TROUBLESHOOTING WARNING: When performing any maintenance and/or trouble- shooting, make sure that all electrical power is off. This means before service, unplug the unit from the electrical outlet or if perma- nently wired, make sure the circuit breaker is in the off position. 1) Remove any dirt or debris which may collect in the bottom of the reservoir tank. - Page 12 DENSO SALES CALIFORNIA, INC. 3900 Via Oro Avenue Long Beach CA 90810-1868 800-264-9573 / 310-834-6352 www.movincool.com DSCA P/N: LA990009-1626 First Issue: February 2005...