Controls; Heating Mode; Cool Air Mode; Tilt Function - Dyson AM04 Operating Manual

Controls

1. Power on
On first use, the heater will default to a temperature
1°C higher than the current room temperature.
Thereafter, the heater will remember the last target
temperature set.

Heating mode

Spot heat
Select a low flow of air.
Whole room
Select a high flow of air.
For best results turn on the oscillation control.
2
2. Thermostat control
Select the desired room temperature. Pressing red
increases the target temperature, blue decreases
it. The heater will not operate unless the target
temperature is above the room temperature.

Cool air mode

Press the blue thermostat control button to change the target
temperature to 0°C. The power button light will change from
red to blue. To adjust the airflow speed use the airflow
speed control.
To return to heating mode
Press the red thermostat control button until the digital display
shows the desired target temperature. The power button light
will change from blue to red.
3. Airflow speed control
To change the airflow speed press the airflow speed
control button. The digital display will show the new
speed; after 3 seconds it will change back to the
target temperature.

Tilt function

Carefully hold the base and the top of the air loop amplifier.
Tilt forward or backward for the required airflow angle.
4. Oscillation control
To start the heater oscillating, press the oscillation
control button. To stop the heater oscillating, press it
again. The heater will not oscillate when the control
buttons are pressed.
Power and remote control*
Stand by
Oscillation
on/off
on/off
Thermostat
Airflow speed
control
control
*Remote control with select models only.
Remote control docks magnetically
Attach remote control to top of heater
with the buttons facing down.
To operate, point remote control toward the front of the base.
3