Do not insert sharp or tiny objects into the Do not place the Network Camera in high Network Camera. humidity environments. Package Contents FD8151V Screws Focus Adjustment Tool Quick Installation Guide / Software CD Alignment Sticker Warranty Card...
Physical Description Leave the slide cover in place if you route cables through the Outer View bottom and then through a hole on the ceiling or wall. Slide cover IR LEDs Inner View Side View RJ-45 Socket Lens Tilt retention Digital input screw Max.
1. It is recommended to use an Ethernet cable that the camera. comes without the strain relief boot. You can remove the boot if your cable comes with one. FD8151V-F2 0002D10766AD Strain relief boot 2. As shown below, you may also route cable from the side.
Page 5
Mounting the Network Camera - Ceiling or Wall Mount 1. Use the alignment sticker as a template to mark where holes will be drilled on the ceiling. Drill two holes into the ceiling; and hammer in the plastic anchors. 2. Drill another hole if you want to route cables through the ceiling or wall. 3.
Network Deployment Power over Ethernet (PoE) When using a PoE-enabled switch This Network Camera is PoE-compliant, allowing transmission of power and data via a single Ethernet cable. Follow the below illustration to connect the camera to a PoE-enabled switch via Ethernet cable. PoE Switch When using a non-PoE switch Use a PoE power injector (optional) to connect between the Network Camera and a non-PoE switch.
2. The program will conduct an analysis of your network environment. After your network is analyzed, please click on the “Next” button to continue the program. 3. The program will search for VIVOTEK Video Receivers, Video Servers, and Network Cameras on the same LAN.
Adjusting the Lens 2. You may also tune the camera's horizontal IMPORTANT: orientation by turning it along its curved screw slots. For the F2 lens: the max. tilt angle is 45°. For other lens: the max. tilt angle is 60°. 1.
Page 9
4. With a live video feed, you can place the included focus adjustment tool carefully on the lens, and use it to turn the lens clockwise or counter-clockwise to adjust to the best image focus. You may try tuning the focus slightly closer due to the concern that focus might be changed when the dome cover is installed.