PANDORA
AUTO-PRINTER
Package Contents
A
B
Robotic Disc Loader
Power Adapter
D
Serial to USB Data Cable
E
G
Spindle
(For Media Insertion / Remove During Use)
F
Disc Bin
/ 1 pc
(50 Discs Capacity)
Disc Bar
/ 4 pcs
(50 Discs Capacity)
C
Device Plate
/ Metal Bar
(2 pcs)
/ Screws
/ non-slip material
(8 pcs)
H
Disc Bin
/ 1 pc
License Dongle
(100 Discs Capacity)
Disc Bar
/ 4 pcs
(100 Discs Capacity)
(Optional)
I
Disc Printer
CAUTION
1
1. Screw the metal bars to the Device
Plate from the bottom side.
(2 pcs)
(4 pcs)
4
(Include disc loader software)
4. Lift the printer's front tray up with both
hands, then pull it out of the paper
position. Completely remove the tray
from the printer. Please set the tray aside
for later use.
(Optional, separate package)
Installation
Printer and Disc Loader software must be installed before proceeding.
2
2. Place the non-slip material in the
designated locations on the metal
bars..
5
The unit should be located so the Disc Bin
has clearance to hang below the DevicePlate.
CAUTION
5. Turn on the printer. It should initialize
and the power light should turn green.
This means the printer is setup correctly.
Remove the Disc Loader each time the printer
is turned o .
Disc Loader Software
Printer Software Disc
3
3. Place the printer on the Device Plate
and press securely against the rubber
feet.
(There should be no gap)
6
6
6. Place the Robotic Disc Loader into
6. Insert the Disc Bars into the Robotic
Disc Loader and the Disc Bin into the
the printer. Ensure that the edges of
Device Plate.
the loader are lined up with the slots in
the printer.
A tone will alert the detection of the device.
V1.7
V1.5