D. Repetitive Information Announcements
Single or multiple informational messages may be repeated continuously or you may use the delay time option for
adding timed intervals between messages.
Up To (3) 8 Ohm
Speakers
VIKING
or (16) 45 Ohm
Speakers
START
E. Single Line, 1-4 Minute Digital Announcer
In this application, the R A D - 1 (Fax Back
Document 410) will answer the line and trigger
the message on the DVA-2W to play from the
beginning.
Note: For this application, the DVA-2W requires
MSG-MOD software (contact Product Support at
(715) 386-8666).
C.O. line or analog
PABX/KSU station
A. Automatic Recording
If only one promotional message is required, the automatic record feature may be used.
Important: The internal shunt must be in the Tape position (see Installation for details).
1.
Move dip switch 3 to the ON position.
2.
Set the volume on the tape player to a
middle setting.
3.
Using the pause key on the tape
player, cue the tape to the blank
section just prior to the message to be
recorded.
4.
Connect the EAR/SPK output from the
tape player to the TAPE/MIC IN jack of
the DVA-2W using a double ended
1/8" audio cord. The LED will light
steady to indicate the DVA-2W is in the
record mode.
5.
Release the pause key on the tape player. The LED will fast flash, indicating the DVA-2W has detected
incoming audio and is recording.
The DVA-2W will automatically stop recording upon detection of 3 or more seconds of silence. Remove the
6.
audio cord to switch the DVA-2W into the play mode.
Notes: If the total available record time is surpassed while recording, the last recorded message will be invalid and
will not play. The LED will pulse hi/lo to indicate that the total available record time has been surpassed. To re-
record the message, remove the microphone plug from the DVA-2W, then insert again into TAPE/MIC IN. This will
clear all previous messages from memory.
B. Manual Recording From a Microphone
If multiple messages are required, the manual record mode must be used.
Important: The internal shunt must be in the MIC position (see Installation for details).
MODEL DVA-2W
©
VOLUME
TAPE/
LED
SPK
COM
CC
AUX
MIC IN
Strap CC to COM for continuous playback
Programming/Recording
Dip Switch Settings
ON
= Continuous
OFF
1 2 3
ON
= 15 second delay
OFF
1 2 3
ON
= 30 second delay
OFF
1 2 3
ON
= 60 second delay
OFF
1 2 3
REMOTE ACCESS DEVICE
VIKING
ELECTRONICS
HUDSON, WI 54016
VIKING
©
MODEL RAD-1
600
: 600
1
2
LINE
LINE
IN
OUT
VIKING
MODEL DVA-2W
©
VOLUME
START
TAPE/
LED
SPK
COM
CC
AUX
MIC IN
Dip Switch Settings
ON
OFF
1 2 3
Note: Using MSG-RLD software,
the delay times may be changed
to 5 minutes, 7.5 minutes, 15
minutes or 30 minutes. For more
information, contact Product
Support at (715) 386-8666.
VIKING
©
3
4
5
VOLUME
START
LED
SPK
COM
4.7 K Resistor
(not included)
EAR/SPK
MODEL DVA-2W
TAPE/
CC
AUX
MIC IN
• • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • •
• • • • • • • • • • • • • • • • • • •
0 0 6
• • • • • • • • • • • • • • • • • • •
MICROPHONE
STOP
REWIND
RECORD
PLAY
PAUSE
VOLUME
Tape Player