Turning On The Power - Toshiba AT100 User Manual

■
Always use the TOSHIBA AC adaptor that was included with your
tablet, or use AC adaptors specified by TOSHIBA to avoid any risk of
fire or other damage to the tablet. Use of an incompatible AC adaptor
could cause fire or damage to the tablet possibly resulting in serious
injury. TOSHIBA assumes no liability for any damage caused by use of
an incompatible adaptor.
■
Never plug the AC adaptor into a power source that does not
correspond to both the voltage and the frequency specified on the
regulatory label of the unit. Failure to do so could result in a fire or
electric shock, possibly resulting in serious injury.
■
Always use or purchase power cables that comply with the legal
voltage and frequency specifications and requirements in the country of
use. Failure to do so could result in a fire or electric shock, possibly
resulting in serious injury.
■
Do not use a 3-pin to 2-pin conversion plug.
■
When you connect the AC adaptor to the tablet, always follow the steps
in the exact order as described in the User's Manual. Connecting the
power cable to a live electrical outlet should be the last step otherwise
the adaptor DC output plug could hold an electrical charge and cause
an electrical shock or minor bodily injury when touched. As a general
safety precaution, avoid touching any metal parts.
■
Never place your tablet or AC adaptor on a wooden surface, furniture,
or any other surface that could be marred by exposure to heat since
the tablet base and AC adaptor's surface increase in temperature
during normal use.
■
Always place your tablet or AC adaptor on a flat and hard surface that
is resistant to heat damage.
1. Connect the power cord to the AC adaptor.
2. Connect the AC adaptor's DC output plug to the DC IN 19V jack on the
tablet.
3. Plug the power cord into a live wall outlet - the Battery indicator on the
display panel of the tablet should glow.

Turning on the power

This section describes how to turn on the power - the Power and Battery
indicators will then indicate the status.
■
After you turn on the power for the first time, do not turn it off until you
have set up the software. Please refer to the section
more information.
User's Manual
TOSHIBA AT100
Initial Setup for
1-3