Troubleshooting - Teac Esoteric G-0Rb Owner's Manual

6 Set the connected units to the slave mode (word
synchronization input mode).
Read the instructions of each component to turn Word Sync
on.
Example:
D-01: select "Rb IN" using the WORD button.
D-70 upgraded: select "WORD+RAM" using the CLOCK
MODE switch (front panel), then select "IN M1" using the
remote control unit.
P-01: select "Rb IN" using the WORD button.
P-70/P-70 upgraded: turn ON the WORD SYNC switch (front
panel), then set the PLL filter switch (back panel) to
"MODE2".
X-01: select "Word M1 ON" using the CLOCK MODE button.
NOTE:
If you connect this unit to other manufacturers units, be sure
to read the manuals of those devices to confirm the frequency
range of synchronization.
Dual AES connection will require you to set the clock
frequency at one half of the audio signal frequency.
< Settings are stored even when power is turned off and the
unit is unplugged.
< When not in use turn off the power switch on the back of the
unit.
< Once settings have been made, those settings can be used
simply by turning on the power the next time the unit is used.
Switch the frequency mode using the FREQUENCY MODE
button depending on the disc to be played or device.
< Although the CD and Super Audio CD frequencies are
multiples of 44.1 kHz while the DVD frequency is a multiple
of 48 kHz, the universal clock enables compatibility with any
disc. The lack of the need to switch the frequency mode for
each disc results in considerable convenience.

Troubleshooting

In case you experience any problem with this unit, please take
the time to look through this chart and see if you can solve the
problem yourself before you call your dealer.
No power
e Check the connection to the AC power supply. Check and
make sure the AC source is not a switched outlet and that,
if it is, the switch is turned on. Make sure there is power to
the AC outlet by plugging another item such as a lamp or
fan.
e Turn on the POWER switch on the rear panel.
Not synchronized
e Check to see if the current word clock output is supported
by the connected players. If necessary, select a word clock
frequency that is appropriate for the individual players.
There are occasions where the word clock available for
synchronization varies depending on the connection and
settings of the individual players. For details, consult the
manual for each player.
e If you are using the PAL FILM mode, check to see whether
the connected player supports the PAL FILM frequency (-4%
of the standard frequency).
e Check to see whether the sync outputs on the rear panel are
connected to the acceptable sync inputs of the individual
players.
Desired frequency not selectable with A, B, and C buttons
e Select the proper fundamental frequency in FREQUENCY
MODE before operating the buttons.
Odd sound pitch
e Do not use the PAL FILM mode for NTSC discs or PAL discs
other than film source discs.
If normal operation cannot be obtained, unplug the power
cord from the outlet and plug it again. This resets the
internal micro-computer which can be disturbed during
electrical storms, power interruptions, et cetera.
11