Talon AM3065 Owner's Manual page 5

HANDLE ASSEMBLY
1. Position the middle handle section (A) over the handle bracket (B) attached to the deck so
that the screw holes on both handles line up. (Fig. 2A)
(A)
2. To attach the middle handle section to the handle bracket you will requie two 51mm
screws(C), two knobs (D), 2 square inset clamps (E), and 2 circular inset clamps (F).
(Fig.2B)
D
Figure. 2B
3. Insert the 51mm screw into the square inset clamp, through both handles and circular
inset clamp and then tighten with knob. Repeat on other side (Fig. 2C)
Circular
inset clamp
Knob
(B)
Figure. 2A
E
C
F
Square
inset clamp
51mm
Screw
Figure. 2C
8
AU
4. To attach the top handle, slide the adjustment teeth of the top handle over the adjustment
teeth of the middle handle. Ensure the screw holes line up. (Fig. 2D)
5. Insert the 2 remianing 45mm screws(G) through the inside of the middle handle section
and then tighten with knobs. (Fig. 2E)
6. To attach the control unit to the top handle place the control unit in the handle adjustment
bracket ensuring that the 4 screw holes line up. Insert screws. (Fig 2)
Screws
Figure. 2D
G
Figure. 2E
Figure. 2F
9
AU