Preparing The Engine; Oil – Sae30; Changing The Engine Oil; Fuel Filling - Talon AM3051SP Owner's Manual

PREPARING THE ENGINE

Please read and understand the engine instructions prior to operating the
lawnmower.
CAUTION
DO NOT START your four-stroke engine before making sure that it has
been filled with the right amount of the correct grade of oil.
OIL – SAE30
Four stroke (cycle) engines are shipped without oil. Place the mower on a level
position, unscrew the 'OIL FILL' cap and slowly pour oil provided into the sump. Fill
to the full mark on the dipstick. The capacity is approximately 500ml. When
checking the oil level, and before running the engine, screw the dipstick firmly in
place.
Checking the oil level with the dipstick.
Fig. 4

CHANGING THE ENGINE OIL.

FOUR STROKE ENGINES should be checked for oil level every 8 hours running (or
Fig. 5
daily), and the oil should be drained and
replaced after every 50 hours of use.
See Engine Lubrication section for oil
change information.
8
AU FUEL
WARNING
Petrol vapour is highly flammable and explosive. Handle with extreme
care. Store in an approved container. Do not fill tank when engine is
running or is still hot. Do not allow open flame, matches or smoking
nearby. Fill tank outdoors in a well-ventilated area. Wipe away any spills
and move the mower away from any petrol fumes before starting engine.
CAUTION
When filling the fuel tank, always leave an air space of about 5mm to
allow for expansion of the fuel.
USE ONLY CLEAN FRESH PETROL AT ALL TIMES, preferably unleaded, with an
octane rating of at least 77. Four stroke (cycle) engines use straight fuel.

Fuel Filling

1. Position the mower on a level surface in a well-ventilated area.
2. Clean around the fuel tank.
3. Remove the fuel tank cap.
4. Place a clean funnel in the fuel filler.
5. Fill the fuel tank with unleaded petrol, allowing room in tank for fuel expansion.
6. Replace the fuel tank cap.
7. Clean up any spilt fuel.
ENGINE.
Regular attention to a few simple items will ensure long and trouble-free service
from your mower. Carry out the regular maintenance described in the manual, and
check the engine mounting bolts regularly to be sure they are tight.
WARNING
Before making any adjustments to your mower make sure that the engine
is turned off and that the blade has STOPPED ROTATING. Always
disconnect the spark plug wire and make sure it cannot accidentally contact
the spark plug before touching anything under the mower housing.
9
AU