Installation Instruction; Electrical Connection; Vi. Electrical Connection - SPT WC-0888H Instruction Manual

V. Installation Instructions
Before using your wine refrigerator
Remove all exterior and interior packing materials.
Check to be sure the following parts are included:
o 3 slide out shelves
o 1 Instruction manual.
Before connecting the appliance to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Place your appliance on a floor that is strong enough to support the
appliance when it is fully loaded. To level your appliance, adjust the front legs
at the bottom of the appliance.
Place unit away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources
may increase electrical consumption. Extreme cold or hot temperatures may
cause the appliance to not perform properly.
Not recommended for use in garage or basement.
The appliance is for indoor use only.
Caution: Please keep the appliance away from flammable substances, which can
cause ignition.

VI. Electrical Connection

Improper use of the ground plug can result in the risk of electrical shock. If the
power cord is damaged, have it replaced by an authorized service center.
This unit should be properly grounded for your safety. The power cord of this
unit is equipped with a 3-prong plug which mates with 3-prong wall outlets to
minimize the possibility of electrical shock. Do not under any circumstances
cut or remove the ground plug.
Use of extension cords is not recommended.
This unit requires a standard 120V-60HZ electrical outlet with 3-prong plug.
The cord should be secured behind the wine refrigerator and not let exposed
or dangling to prevent accidental injury.
WARNING
3