Socket Mobile Power Pack Quick Start Manual

Quick Start Guide
Mobile Power Pack
BOTTOM
Power switch.
Slide outwards to
turn on.
TOP
Low battery LED
© 2009 Socket Mobile, Inc. All rights reserved. Socket, SoMo, the Socket logo, Mobile Power Pack, and Business Mobility Now! are registered
trademarks or trademarks of Socket Mobile, Inc. The Bluetooth wordmark is a registered trademark of the Bluetooth SIG, Inc. USA, and any use
by Socket Mobile, Inc. is under license. All other trademarks and trade names contained herein may be those of their respective owners.
STEP 1: Charge the Mobile Power Pack
1. Turn on the Mobile Power Pack. With the Socket logo facing upwards,
slide the power switch left. If needed, use a pen.
2. Slide the appropriate wall plug for your country into the AC adapter .
3. Plug the AC adapter into the input jack. Plug the other end into an
electrical outlet.
If you forget to turn on the Mobile Power Pack, the LED may blink once
after you plug it into an outlet, but the device will not charge.
If your Mobile Power Pack has very low charge, it will get warm while
starting to charge and gradually cool down.
STEP 2: Connect the Mobile Power Pack to Your Device
1. With the Mobile Power Pack turned on, insert a USB cable/adapter
into the USB port at the top. If needed, use another adapter and/or
booster. Connect it to the charging input jack of your device.
2. Check your device's LED or battery icon to verify that it is receiving
power, and to determine when your device is fully charged.
3. After you have finished using/charging your device, disconnect the
Mobile Power Pack, or it can lose charge, even if your device is turned
off.
To prevent unnecessary discharge, disconnect the Mobile Power Pack
when not in use, including during shipping and storage. Some devices,
even when fully charged, will continue to draw power if left connected.
Package Contents
•
•
•
•
•
•
•
•
•
Input jack
•
•
*More devices may be compatible but have not been tested by
Charging
Socket.
status LED
Device Requirements
•
•
If your device uses higher voltage, boosters are available from
select retailers.
Refer to your device's documentation to verify that it meets the
USB port
voltage requirements before connecting the Mobile Power Pack.
(DC output,
Female USB)
Product Registration
Socket highly recommends that all customers register their
products. Registered users receive priority technical support and
can choose to receive product updates and special offers.
Register online at:
Charging Status LED (RED) – Bottom of Mobile Power Pack
LED
Behavior
While
Charging
Solid red
Blinking red
Off
Off
Low Battery LED (YELLOW) – Top of Mobile Power Pack
LED
Behavior
when
Connected
to Device
Blinking
yellow
Off
Off
Socket Mobile Power Pack
Leather case
Apple iPod Mini retractable charging cable*
6 V booster
Palm charging cable (Treo 650, Tungsten T5)*
Retractable USB A/M to USB A/F cable
3.5 mm barrel connector/adapter
2.5 mm barrel connector/adapter
USB cable with 4.0 mm barrel connector
AC Adapter with wall plugs for USA, Europe, UK, Australia
Travel pouch
Charging/operating power: 5 V to 9 V DC
6 V booster included for devices that use 6 V DC
http://support.socketmobile.com
Provides
Power to
Device?
Yes
Yes
Yes
No
Provides Power
to Device?
Yes
Yes
No
Meaning
Very low charge
Charging and almost fully charged.
The LED will blink rapidly, then slow
down until the batteries near full
capacity.
Fully charged
Deep discharge has occurred – see
reverse for instructions
Meaning
Mobile Power Pack less than 10%
full. Usage not recommended.
Charge soon.
Ready to use.
Mobile Power Pack fully
discharged, cannot be used.
Charge immediately.