Table of Contents
Advertisement
Configuring reports
126
E-Mail Destination
FTP/SFTP/SCP Server
IP
Action
When configuring the FortiAnalyzer unit to email a report, you must first configure
the FortiAnalyzer unit to connect to an email server. For more information, see
"Configuring alerts by email server" on page
If HTML reports are sent to a user that has an email client without supported
HTML, the HTML code for the reports will display in the message body.
You cannot delete a report output configuration if it is already being used in
another report.
Figure 7: Output template
To configure the output for a report
1
Go to Report > Config > Output.
2
Select Create New.
3
Enter and/or select the appropriate information for the fields and check boxes for
the following:
Name
Description
The route the email will take when sent, in the format,
<recipient_email address> (from <sender_email address> through
<email server>).
The type of server that the report will be uploaded to in the format,
<ipv4>(typeofserver). For example, 10.10.20.15(FTP).
Select Edit to view or modify the report output.
Select Delete to remove the report output.
135.
Enter a name for the report. This name only concerns the report
output configuration that you are configuring for your report., not
the report itself.
Enter a description for the report. This is optional.
FortiAnalyzer Version 3.0 MR7 Administration Guide
Reports
05-30007-0082-20080908
Advertisement
Table of Contents
