Table of Contents
Advertisement
Quick Links
T E C H N I C A L
S P E C I F I C A T I O N S
INTRINSIC JITTER
< 140ps RMS measured over a bandwidth
of 10Hz-40kHz
POWER SUPPLY
EI-Laminate power transformer featuring
9 stages of power supply regulation
TRANSPORT MECHANISM
Sony (6 pack Vertical Changer)
Plays 5" discs and 3.5" discs
(3.5" discs - single play only)
HDCD FILTER/DECODER
Pacific Microsonics - PMD 100
D/A CONVERTER
Dual Burr-Brown PCM 1702P
TUBE COMPLEMENT
1-6922/E88CC in a high speed output
buffer configuration
ANALOG OUTPUT
1- pair single ended RCA
DIGITAL OUTPUT
1- AES/EBU on XLR male connector
1- S/PDIF on RCA Co-Ax connector
INFRA-RED OUTPUT
1 - via 3.5mm stereo jack
FREQUENCY RESPONSE
5Hz-20kHz ±.25dB
"A" WEIGHTED S/N RATIO
>-110 dB from 10Hz-20kHz
CROSS TALK
-75dB @ 10kHz
(>-65dB from 20Hz-20kHz)
THD
<.01% from 10Hz-20kHz
MAX. OUTPUT LEVEL
Approx. 2 Volts
POWER REQUIREMENTS
100-120VAC ~ 50/60Hz (1A/250V Fast-Blo fuse)
220-240VAC ~ 50/60Hz (0.5A/250V Fast-Blo fuse)
70VA Maximum
DIMENSIONS
19" (48cm) W x 13" (33cm) D x
5.25" (13cm) H
NET WEIGHT
24lbs (11kg) unpacked
We at Sonic Frontiers hope you will derive many years of
listening pleasure with your new Anthem CD 1. This
Operating Manual contains important information regarding
the operation and care of the CD 1. Be sure to read this
manual carefully and follow these instructions in order to
keep it performing and sounding its best. Please contact
Sonic Frontiers if you have any questions - a Customer
Service Representative will be pleased to assist you.
DANGER:
INVISIBLE LASER RADIATION
POSSIBLE WHEN THE TOP COVER
IS REMOVED. AVOID DIRECT
EXPOSURE TO THE LASER BEAM.
3/2/99 SKU#57553
W H A T ' S
I N
T H E
B O X ?
In addition to the CD 1, its cover, and the operating manual
you are presently reading (with associated inserts and
warranty card), there are a few more items to take inventory of
before steps are taken to make the Anthem CD 1 operational.
These items are:
• one 6922 tube
• a glove for handling the tube
• a detachable AC power cord
• 18 screws
• 1 Philips screwdriver
After completing an inventory of these items, proceed to
the next steps.
Advertisement
Table of Contents
Summary of Contents for Anthem CD 1
- Page 1 (with associated inserts and (>-65dB from 20Hz-20kHz) the operation and care of the CD 1. Be sure to read this warranty card), there are a few more items to take inventory of manual carefully and follow these instructions in order to before steps are taken to make the Anthem CD 1 operational.
- Page 2 Transport mechanisms, which are warranted for a period of or without a visible RA Number on the exterior of the shipping The CD 1 comes with one 6922 tube. The 6922 tube may be replaced with an ECC88/6DJ8 or E188CC/7308 with no twelve (12) months.
- Page 3 (i.e. the CD 1 is on and producing an output signal). 8. Do not remove the CD 1 cover while the unit is “on”, or connected to an AC power source. Cover screws could fall FUSE...
- Page 4 T R O U B L E S H O O T I N G INVISIBLE LASER RADIATION If at any time the CD 1 fails to work properly, consult this checklist: POSSIBLE WHEN THE TOP COVER IS REMOVED. AVOID DIRECT 1.
- Page 5 16 tracks in a program. you do this. You may select a track number before on the disc. When the CD 1 loads a disc into the shuttle previous track on the disc. If you are in Pause and you system, it will read the table of contents of the disc.
- Page 6 DETACHABLE IEC AC POWER CORD SOCKET Plug the Detachable Power Cord into this socket (see Figure 4). The CD 1 is factory set for the correct operating voltage for the area in which it is sold (see shipping box for voltage setting). If a different operating voltage is required, please contact an authorized Sonic Frontiers or Anthem dealer, distributor or the factory directly.
- Page 7 O P E R A T I N G M A N U A L D E S I G N E D A N D M A N U F A C T U R E D S O N I C F R O N T I E R S I N T E R N A T I O N A L 3 5 3 5 L A I R D R O A D , U N I T # 1 6 , M I S S I S S A U G A , O N T A R I O , C A N A D A...
Need help?
Do you have a question about the CD 1 and is the answer not in the manual?
Questions and answers