Pt10-Add Additional Camera Pan/Tilt System Package; Pt10-Add System Components - AMX PT10-ADD Instruction Manual

Additional camera pan/tilt system

Hide thumbs Also See for PT10-ADD:

Instruction manual (26 pages)

Table Of Contents

Table of Contents

PT10-ADD Additional Camera Pan/Tilt

System Package

The AMX Additional Camera Pan/Tilt System adds a single camera pan/tilt package to the

PT10-PLV Single Camera Pan/Tilt System. This system works with both Sony

CMA-D3 camera adapters.

PT10-ADD System Components

AXB-PT10 Pan/Tilt Camera Head

The AXB-PT10 is a fully integrated camera-positioning controller

that provides on-board control of camera pan/tilt, and lens zoom/

focus/iris.

The AXB-PT10 power rating is 2 A @ 12 VDC. This power supply

must be local.

PSN6.5 Power Supply

The PSN6.5 NetLinx Power Supply distributes switched-mode

12 VDC power @ 6.5 A to up to three AMX devices.

The PSN6.5 supplies power to the AXB-PT10 pan/tilt camera

head.

CC-AXL AXlink Connection Cable (4-pin captive-wire to 4-pin

captive-wire, with 2-pin local power connector)

The AXlink cable is used in all configurations, and connects the

AXB-PT10 to the ABS AXlink Bus Strip. The 2-pin connector plugs

into the PSN6.5 to provide local power to the AXB-PT10.

CC-CAM Connection Cable (DB-9 to 8-pin mini DIN)

The CC-CAM cable connects the AXB-PT10 to the DXC-390/950

camera.

This cable is used with any camera powered by a CMA-D2.

CC-CAM Connection Cable (4-pin captive-wire to 8-pin mini

DIN)

The CC-CAM camera/lens cable connects the AXB-EM232

RS-232 control to the CMA-D3 controllers.

This cable is used with cameras powered by a CMA-D3 when an

AXB-EM232 is used as the Master Controller.

PT10 to Camera Lens Cable (DB15 to 12-pin Hirose)

This cable connects the Lens control assembly on the camera to

the LENS control port on the AXB-PT10.

PT10-ADD Additional Camera Pan/Tilt System