Aluratek AIS02F Quick Start Manual

Bluetooth Sportclip
Quick Start Guide
aluratek.com
qsg Q10266 Copyright © 2012 Aluratek, Inc. All Rights Reserved.

Operation

Note: The pairing mode will last 3 minutes. AIS02F will switch to the standby mode automatically if
no devices can be connected within 3 minutes.

Pairing with the transmitter such as iPhone, smart phone, and tablet:

Please make sure the device supports A2DP profile. The pairing procedure will vary
depending on the actual device. Please refer to the user guide of your device for
detail instruction. The general pairing procedures are as follows:
1. Make sure AIS02F is turned Off.
2. Activate AIS02F pairing mode by press and hold the power button for 6-7 seconds.
3. Activate your device's Bluetooth function and set your device to search for Bluetooth
devices. Select AIS02F when it is found.
4. For transmitter with Bluetooth version 2.1, you will not need to input a code. If you
are prompted for PIN, please enter "0000".
5. If prompted by your device to connect, please select "Yes".
6. After connecting successfully, the blue LED will flash twice every 5 seconds.
Note: Please make sure the audio output is set to Bluetooth / AIS02F for audio streaming from the device.

Product Application

Stream music up
to 33' away
Smartphone Tablet LCD display
Volume buttons
Attached clip
AIS02F
Tech Support & Warranty Information
If you need further assistance, please contact the Aluratek support department for
troubleshooting prior to returning this device.
E-mail: support@aluratek.com
Web: www.aluratek.com/support
Local (Tustin, CA): 714-586-8730
Toll free: 1-866-580-1978
Aluratek warrants this product against defect in material or workmanship for
1 Year from the date of purchase.
For more information, please visit: http://aluratek.com/warranty-return-policy
You can register your product online at: http://aluratek.com/product-registration
Operation

Charging the battery

The battery is not fully charged and it is highly recommended that you charge AIS02F
before you begin using it.
Note: Using AIS02F "out of the box" will not harm the device. You will experience reduced battery
life as the unit will not be fully charged.
Headphones Ear buds
Connect the USB end of the cable provided to your PC and the charger plug to the
charging jack of AIS02F. Please charge the battery for a minimum of (3) hours. The Red
Power button,
LED will be on while charging. When charging is complete, the red LED will turn off.
Answer phone
Function
Power On
Power Off
Bluetooth enable your NON
Enter Pairing
Bluetooth headphones or
Mode
earbuds by connecting them
to the Enabler for wireless
audio streaming

Radio and TV Interference Statement

WARNING!!! This equipment has been tested and found to comply with the limits of a
Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by whatever measures may be
required to correct the interference.
Operation LED Indicator
Press and hold Power button for Blue LED - 1 second
3-5 seconds
Press and hold Power button for Red LED - 1 second
3-5 seconds
Ensure AIS02F is turned Off. Press and LED flashes red and
hold button for 6 to 7 seconds until blue alternately
LED flashes red and blue alternately