Figure 3: Brackets For Wall Mounting - Alcatel-Lucent 150 User Manual

Alcatel-Lucent VPN Firewall Brick™
4. Mount the unit on the rack using two screws per bracket or on the wall using one screw per
bracket.
5. Take the power cord that comes with the unit and connect it to the back. See Figure 5 for the lo-
cation of the power jack.
6. Connect the LSMS to one of the Ethernet interfaces on the back (see Figure 5). The following ex-
plains the type of Ethernet cable to use:
•
Direct connection
If you are connecting the LSMS directly to the Brick, use a crossover Ethernet cable.
•
Hub/Switch
If you are connecting the Brick to the LSMS by means of a hub or switch, use regular
Ethernet cables from the LSMS to the hub/switch, and from the hub/switch to the interface
on the back.
7. Connect the LANs to the Brick. Insert the Ethernet cable from the LANs into the remaining
Ethernet interfaces (see Figure 5).
Keep a record of the interfaces to which the LSMS and the various LANs are connected. You will
need this information later when you create security zones and assign them to interfaces.
8. Power the Brick up. It is now ready to be configured, using the LSMS (refer to Configuring and
Activating a Brick

Figure 3: Brackets for wall mounting

in the LSMS Administration Guide for instructions).
®
Lucent Technologies – Proprietary
5
Model 150