Introduction. We congratulate you on the Please visit our site at www.oris.ch for further infor- purchase of your new Oris watch and extend a warm welcome to mation and for a free extended the ranks of mechanical watch guarantee period when you devotees.
The watch is only water-resistant to its specified depth if the pusher deviations will be mentioned for equipped with seals to prevent developed by Oris is simpler to the relevant type of movement. any water penetration. About half release than the screw-down has been screwed down.
Setting and operating Oris watches. Setting T1 (local time): Compass graduation Push the crown back into position 2. Synchronising times, setting the Date, day of the week and time. Worldtimer. Depending on the movement time and date: Press the + or – pusher once for...
Setting and operating Oris watches. and 06.00, take the bigger on the rotating bezel can now stops the chronograph hand once In the above example, it is 11:53 Press the pusher in using an angle between the hour hand and in the 2 time zone.
Crown A, Pos. 3 Press the crown into position 1. ched a high point with the Oris alarm spring winding was used to test and adjust (set) 1938 was a milestone in company Crown B, Pos.
Rotating bezel for measuring time (to open). The rotating bezel on all Oris diving to the nearest hour: watches can only be adjusted in Position the marker on the Even if the valve remains open, an anti-clockwise direction.
Adjusting Oris watches to fit the wrist. (see ‘Fine adjustment of folding Instructions about the kinds of On rubber straps with fold-out leather, rubber, metals used, etc. clasps’). extension for diving suits, fine can found in the ‘Technical adjustment is not possible.
(difference between two rates in the same position) Vmax max. 5 max. 7 tested to tighter tolerance ranges three different temperatures, as than this (see Chapter on ‘Oris shown opposite. Flat-suspended difference Chronometers’). (between horizontal and vertical position) – 6/+ 8 –...
For normal, careful use, Oris recommends general maintenance Metres Feet every 4 – 5 years. (ft) (bar) Hand in your watch to an official Oris retailer or send it to the Oris ✓ service centre in your country. 98.5 – – – –...
Screw down safety wide range of PVD coatings can a synthetic sapphire and is pusher Titanium The grade 2 titanium used by Oris be applied. Essentially, these fall exceptionally scratch-resistant. into four main groups: nitrides, Only diamond, with a Moh is a pure grade of titanium that ß...
❍ 16 ● 20 ❍ 24 early stages of darkness, and is not as scratch-resistant. It is diminishes fairly rapidly during the therefore only used by Oris for ❍ 9 ● 14 ● 3 ❍ 7 ● 10 ❍ 14 ❍...
Afghanistan, India and certain regions of Australia, there are also time differences from UTC of 3½, 4½, 5½ or 9½ hours. Movements. Detailed specifications can be viewed at www.oris.ch . – 11 – 10 – 9 – 8 – 7 –...
Name und address watch stoppage or inaccuracy, etc. guarantee card, the owner of the watch has the right to a repair free of charge. If Oris deems the This guarantee does not affect repair to be unsuitable, the watch your statutory rights.