Onkyo HT-R548 Instruction Manual page 41

Audyssey Settings
■
Audyssey
page 36)
See "Audyssey" (➔
■
Dynamic EQ
See "Dynamic EQ" (➔ page 36)
■
Dynamic Volume
See "Dynamic Volume" (➔
Note
• These technologies can be used when all the following
conditions are met:
– Room Correction and Speaker Setup is completed. Note that
"Audyssey" requires the Audyssey 2EQ Full Calibration
method.
– Speakers A is selected.
– Speakers B is not selected.
– Any listening mode other than Direct is selected.
– A pair of headphones is not connected.
– The input selector other than USB is selected.
• The setting is stored individually for each input selector.
Late Night Function
■
Late Night
For Dolby Digital and Dolby Digital Plus sources, the
options are:
Off
Low:
Small reduction in dynamic range.
High:
Large reduction in dynamic range.
For Dolby TrueHD sources, the options are:
Auto:
The Late Night function is set to "On" or "Off"
automatically.
Off
On
Turn this setting on to reduce the dynamic range of Dolby
Digital material so that you can still hear quiet parts even
when listening at low volume levels—ideal for watching
movies late at night when you don't want to disturb
anyone.
Note
• The effect of the Late Night function depends on the material
that you are playing and the intention of the original sound
designer, and with some material there will be little or no effect
when you select the different options.
• The Late Night function can be used only when the input source
is Dolby Digital, Dolby Digital Plus, or Dolby TrueHD.
• The Late Night function is set to "Off" when the AV receiver is
set to Standby. For Dolby TrueHD sources, it will be set to
"Auto".
page 37).
Music Optimizer
■
Music Optimizer
Off
On
Turn this setting on to enhance the sound quality of
compressed music files. Use it with music files that use
"lossy" compression, such as MP3.
Tip
• Alternatively, you can use the AV receiver's MUSIC
OPTIMIZER.
Note
• The Music Optimizer function only works with PCM digital
audio input signals with a sampling rate below 48 kHz and
analog audio input signals. The Music Optimizer is disabled
when the Direct listening mode is selected.
• The setting is stored individually for each input selector.
• The M.Opt indicator will light
CinemaFILTER
■
Cinema Filter
Off
On
Turn this setting on to soften overly bright movie
soundtracks, which are typically mixed for reproduction in
a movie theater.
CinemaFILTER can be used with the following listening
modes: Dolby Digital, Dolby Digital Plus, Dolby TrueHD,
Dolby Pro Logic II Movie, Multichannel, DTS, DTS
Neo:6 Cinema, DTS 96/24, DTS-HD High Resolution
Audio, DTS-HD Master Audio and DTS Express.
Note
• The CinemaFILTER may not work when used with certain input
sources.
(➔ page 8).
En
41