Miele FN 4697 S Operating And Installation Manual page 30

^ the ventilation gaps are blocked.
^ there has been a lengthy interruption
to the power supply.
Once the problem has been resolved
the temperature display will light up
constantly and the alarm will stop.
Check the temperature display about 6
hours after switching on the appliance.
The display will not show a temperature
until the temperature in the appliance
has reached a certain level.
There is a fault. Call the Service
Department.
nA
The temperature has risen too high at
some point during the last couple of
days because of a power cut.
^ Press the alarm button whilst " nA " is
lit up in the display.
The temperature display will show the
warmest temperature recorded in the
appliance during the power cut.
Depending on the temperature
displayed, you should check the
condition of food in the freezer. If it has
defrosted or started to defrost check
that it is still safe to use and if so use it
as soon as possible. Defrosted food
may only be re-frozen after it has been
cooked.
30
The warmest temperature will show in
the display for about 1 minute. The
actual current temperature in the
freezer will then show in the display
again.
The indicator light is defective. Call the
Service Department.
The safety lock has been activated.
F1 F5
^ Was the door left open for too long?
If this is not the case, then the lamp is
defective:
^ Disconnect the appliance from the
^ Unscrew the lamp and replace it with
The lighting switches itself off
automatically after approx. 15
minutes.
mains. Switch off at the wall and
withdraw the plug from the socket, or
disconnect the mains fuse or remove
the screw-out fuse in countries where
this is applicable.
a new one.