Miele FN 4693 S Operating And Installation Manual page 31

. . . the alarm sounds and the
temperature display flashes.
^ Has the appliance door been open
for longer than 60 seconds?
The freezer temperature has risen
above the temperature set because
^ the door has been opened too
frequently, or large amounts of fresh
food have been put in at once for
freezing.
^ the ventilation gaps are blocked.
^ there has been a lengthy interruption
to the power supply.
Once the problem has been resolved
the temperature display will light up
constantly and the alarm will stop.
. . . a bar is lit up or flashing in the
temperature display.
Check the temperature display about 6
hours after switching on the appliance.
The display will not show a temperature
until the temperature in the appliance
has reached a certain level.
. . . the following messages show in
the temperature display "F1" to "F5".
There is a fault. Call the Service
Department.
Problem solving guide
. . . "nA" appears in the temperature
display.
The temperature has risen too high at
some point during the last couple of
days because of a power cut.
^ Press the alarm button whilst " nA " is
lit up in the display.
The temperature display will show the
warmest temperature recorded in the
appliance during the power cut.
Depending on the temperature
displayed, you should check the
condition of food in the freezer. If it has
defrosted or started to defrost check
that it is still safe to use and if so use it
as soon as possible. Defrosted food
may only be re-frozen after it has been
cooked.
The warmest temperature will show in
the display for about 1 minute. The
actual current temperature in the
freezer will then show in the display
again.
. . . the Super freeze indicator light
does not light up although the
appliance is working.
The indicator light is defective. Call the
Service Department.
. . . you cannot switch the appliance
off.
The safety lock has been activated.
31