Table of Contents
Advertisement
^ Push the appliance into the niche.
Make sure that the mains cable does
not get trapped.
^ Depending on the thickness of the
appliance housing walls, push the
appliance into the niche until
– the spacer piece touches the hous-
ing unit wall a (16 mm thick walls),
– or the front edges of the hinges are
flush with the side walls of the hous-
ing unit b (19 mm thick walls).
The cover strip must
front of the edge of the housing unit.
It must disappear completely into
the niche.
^ Push the hinged side of the appli-
ance to the furniture wall.
^ The appliance height can be cor-
^ Secure plastic bracket c to the side
^ Push the appliance in until the plastic
^ To fix the appliance to the housing
protrude in
^ Screw a long 4 x 19 mm chip board
rected by altering the adjustable feet
using the spanner supplied f.
opposite the hinges using the
M5 x 22 countersunk screws d.
bracket is flush with the front edge of
the housing unit floor e.
unit at the top and bottom screw the
long 4 x 19 mm chip board screws a
loosely into the hinge.
screw b loosely into the middle of
the long slot on the plastic bracket
and then turn the plastic bracket c
downwards.
35
Hide quick links:
Advertisement
Table of Contents
