Vivitar ViviCam F314 User Manual page 6

When powering the camera ON for the first time the camera will take you through the initial
camera setup.
Powering the Camera ON
1) Make sure the batteries have been inserted properly into your digital camera.
Use 3x AAA (1.5v) batteries. Alkaline batteries are recommended.
2) Make sure an SD card has been properly inserted into your camera (until a click sound is
heard).
Note: After the camera is powered on, an SD icon will appear on the LCD display.
If you do not see the SD icon on the display, please check if the card was inserted properly.
3) Press the POWER button to turn on the camera.
Setting the Camera Language
1) You will first be prompted to select a language for the camera. The Language selection
menu will appear. Select the language of your choice by pressing the UP and DOWN
buttons. Then press the MENU (M) button to confirm the selection.
2) After selecting a language, you will be asked if you would like to continue with the initial
camera setup. A message will appear: "Continue with Camera Setup?" Select "Yes" to
continue or "No" to exit the setup.
Note: If you select "No" and decide to leave the camera setup, the camera will be set to its default
settings. These settings can be adjusted at any time manually through the menus in the camera.
Setting the Date and Time
The next step in the initial camera setup is to set the date and time on the camera.
Set the Date and Time as Desired and press the MENU (M) button to confirm the selection and
move to the next part of the camera setup.
5