Vivitar ViviCam S332 User Manual page 6

When powering the camera ON for the first time the camera will take you through the initial
camera setup.
Powering the Camera ON
1) Batteries
Make sure the batteries have been inserted properly into your digital camera, according to
the polarity shown inside the battery compartment.
Use 3 x AAA (1.5V) batteries. Alkaline batteries are recommended. (Batteries not included.)
Note:

Remove the batteries from the camera when not in use for an extended period.

Do not mix alkaline and non-alkaline batteries.

Some features, such as Flash, will not work if the battery power level is low.

When the battery power is low the battery icon turns red and the camera will
automatically turn off a few seconds later.

Rechargeable batteries not recommended.

The energy status of the power is displayed on LCD as shown below:
Full battery power
2) SD Card
Make sure an SD card has been properly inserted into your camera. (SD card not included.)
To properly insert the SD Card:
Push the SD card into the slot in the direction shown on the camera (see SD icon by the SD
card slot). Push the SD card until you hear a slight clicking sound. This indicates the SD
card has been inserted correctly.
Medium battery power
5
Low battery power