Mylex Disk Array controller Installation Manual And User's Manual page 34

Global Array Manager (GAM)Server Software for NetWare 4.11/4.2 and 5.0
• (For NetWare 4.11/4.2): Uncomment the load aspitran
command line.
• (For NetWare 5.0): Modify the NWASPI.CDM line by specifying
the pathname for the exact location of NWASPI.CDM.
• If you wish to enable RAID Fault Management (RAIDBUILD) and
optionally change its default parameters, you need to modify the
RAIDBLD command line installed in AUTOEXEC.NCF. Refer to
Appendix C: "RAID Fault Management" for information.
• If you will be using drives from more than one vendor in the same
RAID Group, refer to Appendix E: "The MYLEXDRV.SIZ File" for
information on setting drive size limits for consistency across
multiple vendors' drives.
7. Be sure to remove comment markers (such as the character #) from any
command line which you intend to enable.
8. Save the modified AUTOEXEC.NCF and exit.
9. Create a user account called gamroot. Assign Supervisor access
privileges to that user account.
10. Restart the server. See "Running Global Array Manager Server" on
page 2-15 after verifying correct server software installation.
2-14 Disk Array Controller Software Kit User's Manual