Wintal HDMI over CAT-5e Extender Instruction Manual

HDMI over CAT-5e Extender Instruction Manual
The HDMI extender includes two units: transmitter & receiver units. The transmitter is
used to capture the input HDMI signals and carries the signals thru two RJ-45 connectors
into two low cost CAT-5e cables. The receiver is responsible for equalizing the sent
TMDS multimedia data. With equalization control switch on the receiver, users can adjust
the equalization strength to the received TMDS signals, and therefore optimize the
transmission distance between source and destination.
Feature
1. Use CAT-5e cable to substitute HDMI cable to achieve long distance transmission.
2. Extend up to 55 meters @ 1080i, 60Hz.
3. Extend up to 30 meters @ 1080p, 60Hz.
4. Cable skew adjustable equalization with 8 levels.
5. HDCP compliant
Specification
1. Video bandwidth: 2.25 Gbps (HDMI 1.3a)
2. Deep color support: up to 12 bit
3. Input TMDS signal: 1.2 volts (peak-to-peak)
4. Input DDC signal: 5 volts (peak-to-peak)
5. HDMI connector: 19 pin type female connector
6. Power supply: 5V, 2A
7. RJ-45 connector: 2 indication LEDs
Panel Descriptions
Transmitter
HDMI INPUT: Connect a HDMI source with a HDMI M-M cable here.
TMDS: Plug in a CAT-5e cable that needs to be linked to the TMDS connector of the
Receiver.
DDC: Plug in a CAT-5e cable that needs to be linked to the DDC (HDCP) connector
of the Receiver.