!
NOTE: This device requires another HomePlug (MegaPlug) compatible
device connected to your modem or router in order to function. If you
do not have another HomePlug compatible device, you may order one
by visiting www.actiontecstore.com/homeplug
A
Connect the Hub to a Device
1
Step
Get the MegaPlug
85 Mbps 4-Port Hub from the
Quick Start Kit.
2
Step
Get the Gray Ethernet
Cable.
3
Step
Plug one end of the
Ethernet Cable into any open
Ethernet Port on the back of the
MegaPlug 4-Port Hub.
Note: An Ethernet port looks similar to a phone port but is slightly larger.
4
Step
Plug the other end of the
Ethernet Cable into an OPEN
Ethernet Port on your computer
or other device.
Questions? Call 1-888-436-0657 (USA)
5
Step
Get the Power Cord
from the Quick Start Kit.
6
Step
Plug one end into the AC
In Port located on the back of the
MegaPlug 4-Port Hub.
7
Step
Plug the other end into a
Power Outlet.
Do NOT plug the Hub into a power
strip or wall outlet that uses surge
protection as the Hub may not work.
B
Install the Configuration Utility
Note: You do not need to complete this section if you connected the Hub to a
device other than a Computer. This utility can be used to adjust the security
settings of the Hub. For more information, see the User Manual which is located on
the Installation CD-ROM.
1
Step
Get the Installation CD
and insert it in the computer's
CD-ROM Drive.
Flip this Quick Start Guide over to continue
Questions? Call 1-888-436-0657 (USA)
NEXT
Need help?
Do you have a question about the MegaPlug HPE400T and is the answer not in the manual?
Questions and answers