Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Metronic T2 HD zapbox
Summary of Contents for Metronic T2 HD zapbox
- Page 1 T2 HD zapbox Digital TV Receiver USER MANUAL...
-
Page 2: Table Of Contents
Contents Automatic Channel Scan ......14 Accessories ............2 Manual Channel Scan ........14 Introduction ............. 2 First Time Installation ........14 Safety Precautions ..........2 OSD Warning Messages ........15 Overview of the Remote Control ......4 No Signal ............15 Viewing Controls and Connections of the Set Top No Channels Have Been Added Yet .... -
Page 3: Accessories
corresponding instructions of this handbook prior to Features the first usage of the device, even when the usage • DVB and VBI teletext. of electronic devices is familiar to you. • 200 channels • Please read the chapter SAFETY PRECAUTIONS and INFORMATION. -
Page 4: Important Safety Information
Important Safety information Mains supply This equipment is designed to operate from a 220-240 Volt, 50Hz AC mains supply. Other power sources may damage it. Check that the rating label on the back of the mains adapter states 220-240V AC before you plug it in for the first time. -
Page 5: Overview Of The Remote Control
Overview of the Remote Control English - 4 -... -
Page 6: Viewing Controls And Connections Of The Set Top Box
Viewing Controls and Connections of the Set Top Box Front Panel PROG DOWN DISPLAY ON/OFF PROG Rear Panel HDMI OUTPUT OPTICAL ETHERNET AUDIO OUT 1. ANTENNA IN : You can connect the antenna to the aerial input of the box. 2. -
Page 7: Inserting Batteries In The Remote Control
Inserting Batteries in the Remote Control • Remove the battery cover located on the back of the remote control by gently pulling back the indicated part. • Insert two AAA/R3 (2 X 1.5Volt) or equivalent type batteries inside. Place the batteries in the right direction observing the polarity symbols (+/-) and replace the battery cover. -
Page 8: Antenna Connection
Power Connection IMPORTANT: The set-top box is designed to operate on 12V DC. For this, an adaptor is used which supplies a 12V DC voltage. Connect this adaptor to a mains socket that supplies 220-240V AC,50Hz. • After unpacking, allow the set-top box to reach the ambient room temperature before you plug it in to the mains for the fi... -
Page 9: First Time Installation
• Select Yes or No by using “ ”/“ ” buttons. Press OK First Time Installation to continue and the following message will be displayed on the screen: IMPORTANT: Ensure that the aerial is connected before switching on the set-top-box for the fi rst installation. -
Page 10: On-Screen Information
Volume Up / Down • To exit from a menu screen, you can press MENU button. • You can increase or decrease the volume by using • The following items are located in the main menu V+ / V- buttons. screen: •... -
Page 11: Operating The Channel List
• If the selected channel is password protected, parental current character, i.e., ‘b’ character becomes ‘a’ by lock password will be asked. If the correct code is pressing “ ” and ‘c’ by pressing “ ”. entered, selected channel can be watched. •... -
Page 12: Event Options
Viewing Electronic Programme Guide (EPG) You can view the electronic programme guide (EPG) to view information about available programmes. Select Programme Guide from the main menu by using “ ”/“ ” buttons. Press OK to continue. HINT: You can also press GUIDE button to view the EPG menu. -
Page 13: Scan Encrypted
AC3 Audio • Select Active Channels by using “ ”/“ ” button. • You can select a broadcast type option from the list • Highlight the AC3 Audio item by pressing “ ”/“ by using “ ”/“ ” button. Available modes are: TV ”... -
Page 14: Parental Settings
• You can use this feature, only if the broadcaster be broadcast. If found, the box will download new supports that additional narration track. software automatically. This operation will normally take approximately 30 minutes. • You can enable or disable automatic upgrade by setting Automatic Scanning option. -
Page 15: Current (*)
• Audio: Sets the preferred audio language. • Subtitle: Sets the subtitle language. Selected language will be seen in subtitles. • Guide : Sets guide language. Current (*) (*) These settings can only be changed if the broadcaster supports them. Otherwise, settings will not be available for change. -
Page 16: Osd Warning Messages
• After you select Yes, factory settings will be loaded. • Installation wizard will guide you through the installation process. See the section, “First Time Installation” in previous chapters for more information on this process. OSD Warning Messages • Some warning messages may appear on the screen indicating that a related function may not be working properly. -
Page 17: Troubleshooting
Troubleshooting Problem Possible Reasons What To Do Check if the AC Adaptor is Connect DC lead to 12 Volt DC The LED indicator does not plugged into the power socket socket on the box ensuring its all glow. and switched on. the way home. -
Page 18: General Characteristics
General Characteristics Supply Voltage for set-top box: 12 V DC Supply Voltage for DC Adaptor : 220 - 240 V AC ~ 50Hz Input Frequency 470Mhz-862Mhz Maximum Power consumption 15 W Typical Power consumption Standby Power Consumption <1 W USB (optional) Current Limit 500mA Operating temperature 5ºC to +40ºC... -
Page 19: Audio
Audio Output 2 Vrms, 0 dBfs / Z = 10 kohm Digital Audio Output Optical SPDIF A / V & Data In / Out Scart TV scart RGB Video Output TV scart CVBS Video Output TV scart Analogue Audio Output TV scart Digital Audio Output Optical output... - Page 20 If the item is shown to have had an inherent defect present at the time of sale, the store will provide you with a replacement. Your statutory rights remain unaff ected. Metronic Ltd Park House 15-23 Greenhill Crescent Watford WD18 8PH www.metronic.com...
- Page 21 Following information is only for EU-member states: The use of the symbol indicates that this product may not be treated as household waste. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
Need help?
Do you have a question about the T2 HD zapbox and is the answer not in the manual?
Questions and answers