Honda 2008 Fit Owner's Manual page 203

HOLD-DOWN ELECTRICAL
WIRE BULB CONNECTOR
RUBBER WEATHER SEAL
Remove the electrical connector
3.
from the bulb by pulling the
connector straight back.
4. Remove the rubber weather seal
by pulling on the tab.
5. Unclip the end of the hold-down
wire from its slot. Pivot the wire
out of the way, then remove the
bulb.
6. Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
HOLD-DOWN
WIRE
INSPECTION WINDOW
Make sure that the hold-down
7.
wire is installed properly and
securely. You can check its
installation from the inspection
window on the headlight assembly.
8. Install the rubber seal over the
back of the headlight assembly.
CONTINUED
Lights
197