Advertisement
Sharp Installation
System 8/10 Plus to Sharp XG Series Projector Connections (RS-232)
________ Important note! For Sharp projectors which do not allow simultaneous
________ When RS-232 control of the projector is used, the projector's IR remote can be
________ If the installation includes looping (master/slave) switchers, see Chapter 5 of the
________ If Video Loop Back is part of the installation, refer to pages 2-10 and 2-11.
Extron • System 8/10 P
LUS
Use the illustration below as a guide when connecting the System 8/10 Plus to a
Sharp projector. Refer to Sharp documentation to continue the installation.
connections to S-Video and Composite Video (see last note on previous page),
please refer to the following diagram where either S-Video or Composite Video
may be connected, but not both at the same time. For those Sharp projectors
which will allow you to connect to S-Video and Composite Video sources
simultaneously - please refer to the inset diagram below.
Composite
Video
or
S-Video
VIDEO INPUT
S-VIDEO
VIDEO
IN
DO NOT
1
CONNECT
HERE
IN
CONNECT
2
HERE
Composite
Video
and
S-Video
used. However, because the projector's IR remote does not communicate with
the System 8/10 Plus switcher, the projector and switcher can become out-of-
sync if the projector's IR remote is used to change the projector's input, picture
mute or power settings. Should this occur, press the power, mute or channel
buttons on the switcher to allow the projector and switcher to resynchronize.
System 8/10 Plus User's Manual.
• User's Manual • P/N 68-409-01 Rev. C
Configuration and Connections
Universal
9-Pin Male
CommAdapter
26-467-01
9-Pin Female
VIDEO INPUT
AUDIO INPUT
PC CONTROL
S-VIDEO
VIDEO
L
R
COMPUTER RGB
INPUT 1
VIDEO OUTPUT
FILTER
R
G
ON
OFF
RGBHV 5 BNC
MOUSE
FOR PC98
WIRED
REMOTE
AUDIO OUTPUT
COMPUTER
OUTPUT
AUDIO IN
L
R
DC5V OUTPUT
INPUT 2
MAX CURRENT 1A
B
H
V
-
+
Composite
Video
or
15-Pin
S-Video
Male
Page 3
Advertisement
