Ce Declaration Of Conformity; Fcc Notice - Linn AKTIV Crossover Owner's Manual

CE Declaration of Conformity

Linn Products Ltd declare that this product is in conformance with the Low
Voltage Directive 73/23/EEC and Electromagnetic Compatibility 89/336/EEC
as amended by 92/31/EEC and 93/68/EEC.
The conformity of the designated product with the provisions of Directive
number 73/23/EEC (LVD) is proved by full compliance with the following
standards:
Standard number Date of issue
EN60065
The conformity of the designated product with the provisions of Directive
number 89/336/EEC (EMC) is proved by full compliance with the following
standards:
Standard number Date of issue
EN55013
EN55013
EN60555-2
EN60555-3
EN55020

FCC notice

NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
1993
1994
1994
1987
1987
1994
iv
Test type
General requirements
Marking
Ionizing
Heating under normal conditions
Shock hazards under
normal operating conditions
Insulation requirements
Fault conditions
Mechanical strength
Parts connected to the
mains supply
Components
Terminal devices
External flexible cords
Electrical connections and
mechanical fixings
Test type
Conducted emissions
Absorbed emissions
Harmonics
Voltage fluctuations
Immunity