Advertisement
4
Sleeve
Side Tube
• Slide a side tube, straight end first, through the sleeve on each
side of the net.
5
Side Tubes
• Lift the side tubes up and set the ends in the notch in each
base assembly.
Hint: The top of the net will flop forward.
ASSEMBLY
ASSEMBLY
Sleeve
Side Tube
6
• Fit the upper end of the side tubes into the groove in each post.
7
2
Base Covers
• Note the numbers on the base covers.
• Fit the base cover labeled
Hint: Make sure the net is not under the base cover.
• Insert four #8 x
/
" screws into the base cover and tighten.
3
4
• Repeat this procedure to attach the other base cover labeled
to the base assembly labeled
2
4
4
Post
Grooves
1
onto the base assembly labeled
1
.
2
.
1
Advertisement
