Fisher-Price GROW TO PRO BASKETBALL 72408 Instruction Sheet page 3

5
Rim
• While holding the ring assembly and rim together,
turn them over.
• Insert four screws into the holes in the rim, making
sure each hole in the rim is still aligned with each
screw hole in the net assembly.
• Partially tighten the screws with a Phillips screwdriver.
Turn the rim over to ensure that the net loops are still
in the grooves and through the ring tabs before
completely tightening the screws. Do not over-tighten
the screws.
6 Curved
End
4
Upper Post
5
6
Large Square Opening
Base
• Position the base as shown.
• Position the upper post so that the straight end is
down and the curved end is up and facing away from
the base.
Hint: For easier assembly, apply liquid soap or rub a
candle or bar soap around the bottom of the upper post
(especially on the corners) and the inside of the large
square opening. If assembling inside, place a tarp
under the base to protect the floor surface.
• Insert the upper post into the large square opening in
the base and, using a circular motion, push it all the
way down.
Assembly
7
Rectangular Tab
Upper Post
4
Rim
5
6
• Hook the rectangular tab on each side of the rim to
the upper post, as shown.
• Rotate the rim down until it snaps into place on
the upper post. Push down on the rim to be sure
it is secure.
Wall
8
Backboard
Rim
4
Groove
5
Upper Post
Peg
6
• Lean the rim against a wall for support.
• Locate the pegs on each side of the rim and the
grooves on the backboard.
• Position the backboard with the Fisher-Price
facing up.
• Place your foot on the base to hold it steady and slide
the backboard onto the upper post at an angle, as far
as it will go.
Note: There should be no gap between the upper post
and the backboard.
• Move the assembly away from the wall.
4
9
PULL HERE
PRESS HERE
• Move to the side of the assembly.
• Place your foot on the base to hold it steady.
• Press down firmly on the lower backboard while
rotating the backboard up.
• When properly assembled, the pegs on the upper
post rest in the grooves in the backboard, as shown.
Note: The height of the rim is three feet as assembled.
10
Fisher-Price ®
Logo
Base
IMPORTANT! Assembly of the lower post is a
permanent assembly.
• Align the rib on the bottom of the lower post with the
logo
®
groove in the opening in the base.
Hint: For easier assembly, apply a small amount of
liquid soap around the bottom of the post. If assem-
bling inside, place a tarp under the base to protect
the floor surface.
• Insert the lower post into the opening and push down,
using a circular motion, until it snaps into place.
Assembly
11
Grooves
Peg
Peg
Top View
Back View
Note: The collar may already be factory assembled.
• Align the lever on the side of the collar with the
opening in the top of the lower post.
• Fit the collar onto the lower post, making sure the peg
on each side of the collar snaps into the hole on each
side of the post.
12
Lower Post
4
Rib
5
• If the lever comes off, simply re-attach it.
6
• Insert the peg on one side of the lever into the hole in
the collar.
Groove
• Snap the other peg in the lever into the other hole in
the collar.
Assembly is now complete.
Please refer to assembly step 2 to fill the base with
water or approximately 50 lbs. of sand (water and sand
not included) to keep this product stationary.
5
Collar
Peg
Lever
Hole
Opening
Lower
Post
Peg
Peg
Holes