Making It Go; Connecting Your Vc3Q - Joemeek Pro Channel VC3Q User Manual

MAKING IT GO

CONNECTING YOUR VC3Q

The VC3 can be used in many applications, from recording to live work.
This section will help you get connected as well as explaining the
connections on the VC3Q to help you get the most from your Pro Channel.
Sample recording set up
Here, we are using the VC3Q as a replacement front end for a mixing desk/
hard disk recording setup. This configuration may be used for a
performance vocal or instrument source in the studio to get richer sounds
on disk, as well as eliminating any digital delay when monitoring.
Mic Gain
20
15
25
6
0
5
10 35
4
3
5
2
1 11
Comp On
0
60
Compression
Phantom
Input Gain
WARNING! Removal of cover
JOEMEEK
may expose dangerous voltages
No user servicable parts inside
FLETCHER ElectroAcoustics Ltd. ENGLAND.
Only use power Out 2
supply provided
Power 12V AC
To Recorder
The mix input may be used to add additional sources at the performance,
and the insert point may be used to add effects by diverting the line level
signal through and external processor (i.e. reverb unit or amp simulator).
This use of the VC3Q will improve the quality of sound recorded by its high
performance mic/instrument amplifier. Also, the compressor will
significantly improve the perceived impact of a sound.
Note that the compressor and equalizer may be added to a track after it has
been recorded by using the line input from recorder group output.
VC3Q
Pro Channel
MIC PRE - OPTO COMPRESSOR - MEEQUALIZER
6ms 700ms
7 5ms 7ms 800ms -3
1s -6
-10
1ms 11ms 125ms 1.5s -16
Attack Release In Low
EQ
VC3Q
Made in England by
C C www.joemeek-uk.com
Out 1 Mix In
To Mixing Desk
(For monitoring,
bypassing monitor delay)
- User's guide
JOEMEEK
0 0 0
+3 -3 +3 -3 +3
¥
+16 -16 +16 -16 +16
Mid High
(80Hz) (1.8kHz) (8kHz) O/L
Mic In
Insert Line In
Phantom
9
VC3Q
-10
0
Q
+2
+4
dB Input Meter
(Front)
+6
Out Vol
On -12 -6 0 +8
(Rear)
Microphone In
(or)
Instrument In