Needle Threader; Drawing Up Bobbin Thread - Janome 419S Instruction Book

1
2
3 4
1
2
3

Needle Threader

1
Raise the needle to its highest position.
Press down the needle threader knob as far as it will go.
The hook comes out through the needle eye from behind.
2 Pull the thread down around the thread guide then pass
it from the left and under the hook.
3 Release the knob slowly while holding the thread end
with your hand.
A loop of the thread is pulled up through the needle eye.
4 Remove the loop from the threader and pull out the
thread end from the needle eye.
Note:
The needle threader can be used with a #11/75
to #16/100 needle or Janome Blue Tipped needle.
Thread size 50 to 100 would work well.
Caution:
Be sure to raise the needle to its highest
position when using the needle threader,
otherwise the hook will miss the needle eye
and will be damaged.

Drawing Up Bobbin Thread

1 Raise the presser foot and hold the needle thread
lightly with your left hand.
2 Turn the handwheel one complete turn toward you
and raise the needle to its highest position.
Pull the needle thread to pick up a loop of the bobbin
thread.
3 Pull 15 cm (6") of both threads back and under the
presser foot.
10